Z-TAC airsoft gear
PRODUCT​
   ​COMING SOON         HISTORY        VIDEO&REVIEW
English
简体中文

Attach support strap to right Earcup: Orient the right earcup and one of the support straps upward(as shown below), Then slide the lower portion of the earcup through the elastic cord so the labe1 on the support strap is visible from the Outside.Once the elastic cord is positioned below the outside.Oncethe elastic cord is positioned below the support mounts on the front and back  of the earcup you are ready to proceed to the next step.

Then reach over the top of the right earcup and locate the elastic cord on the inside of the earcup and pull it over the top of the earcup as shown below using your fingers so a loop is created around support mounts.
 Now separate the flag of the support strap and slide it  under the upper portion of the elastic cord.Then secure  with the upper portion of the support strap with the  Velcro.​​

Now align the elastic cord as shown below.It is important that the lower portion of the elastic cord remains below the support mounts as highlighted by the arrow below.

Next,adjust the position of the support strap so it is centered on the earcup.

Attach support strap to left Earcup;In this case, the headset has the boom microphone and attached to the left earcup.


Postion the support strap with the boom microphone and headset cable inside of the elastic loop,  as shown below.

Then postion the support strap so it is centered on the earcup and the elastic cord is aligned with the bottom of the support mounts as shown below.​

Once again,reach over the top of thr left earcup and grip the elastic look with your fingers.Then pull the elastic loop over top of the earcup

Now align the elastic cord as shown below.It is important that the lower portion of the elastic cord remains below the support mounts as high-lighted by the arrow below.

Now separate the flap of the support and slide it under the upper portion of the elastic cord .then secure with support strap with the Velcro.


Now fasten the tab to the back of the support strap using Velcro and center the strap on the earcup.


Once both support straps have been attached,your set-up should look like this and we can proceed to helmet inergration steps and recommendations.

Now it’s time to attach the left support strap to the helmet using the Velcro loop material on the helmet to approximate the fit of the headset with the helmet.You can fine tune the fit a little later.

The following photo depicts the way your helmet harness and chinstrap should aligned .Take note outside of the left harness  webbing as opposed to the inside of it.

The design of the support strap system accommodates equipment you might have attached to the helmet rails so no loss of rail functionality is lost when using our support straps.

Customers also like the ability to easily separate the headset and helmet so either can be used independently.Z-TAC’s support strap system enables the user to quickly and easily use the support strap when not using a helmet.The nice thing is the removal of the headset from the helmet only take a few seconds,giving you alternative options,unlike systems that requires hardware to attach the headset to helmet rails.